What is a good rack that can hold several skateboard decks and doesn't cost a ton or hang over a door? What is the toughest brand of skateboards and skateboard trucks?
Jan 21

how to put on skateboard wheels and trucks?

skateboarding wheels Add comments

I am trying to put put the wheels on my son's new skateboard board but the bearings keep coming out. I am not sure if I am doing it right.

this makes easier……

http://www.skateboard-city.com/how-to-assemble-a-skateboard.html

it teaches you all the steps…..just follow them….

written by admin

3 Responses to “how to put on skateboard wheels and trucks?”

  1. You're The Dream, Unicorn! Says:
    January 21st, 2009 at 12:13 pm

    this makes easier……

    http://www.skateboard-city.com/how-to-assemble-a-skateboard.html

    it teaches you all the steps…..just follow them….
    References :
    I skate…..

  2. O Says:
    January 21st, 2009 at 12:55 pm

    The polyurethane is worn at the point of contact for the bearing. You can still skate on this for a while but eventually the slop from the wheel and the bearing will cause the bearing to break and seize. Buy new wheels from a proper skate shop or even take the wheel in and they might be able to put a bigger bearing in the wheel that is snug. As for the trucks there should be alignment holes to put on the board, if there isn't then check on line to find precise measurements for drilling holes on the board. Skate shops are affordable and can help a lot though.
    References :

  3. nR Says:
    January 21st, 2009 at 1:24 pm

    probably a little late but take it to a skateshop and watch them do it. it takes a little bit of pressure to get the bearings in there. you need to make sure they are on right.
    References :

Leave a Reply