Skateboard Planet

2 Responses to “How will I build my own skateboard ramp????”

1. Matt Says:
   January 13th, 2009 at 1:56 pm

   well…im sure its much easier to just buy a ramp..u can buy them at sporting good stores
   References :

2. kamokid95 Says:
   January 13th, 2009 at 2:42 pm

   hey its simple me n my friends built a skatepark b4

   it depends on what kid of ramp u want
   we mostly built quarter pipes

   ok but first u go get all the stuff you need

   some ply wood (not that scatter crap u cant ride on it)
   you need 3 sheets of ply wood probly 4 if you want a deck
   make sure one can flex to go on the transition.

   and you need 2×4's depending on how tall and wide you want the ramp affects how much 2×4's youll need

   then you need your screws and etc.

   but you lay two sheets of ply wood on top of each other and clamp them or do something to hold them together.
   then you draw out your transtion and if you want a deck remember to draw it out to!!

   then cut out the transition.

   then decide how wide you want the ramp.
   once you decide cut all your 2×4s to that length(remember the deck has to go on top so u might want to cut about half an inch shorter)
   then for this you will need some help

   you stand up one transition and have some1 else hold the the otherthen screw one 2×4 to the bottom at the back
   and then one in the front but make sure it isnt so tall that it is
   taller than the transition
   then once you have thous on the bottom do one on the top
   then it should be stading by itself then al the way down the transition put 2×4's like you did before thenit should look like a quarter pipe with out the part u ride on
   then take the oher pice of ply wood and screw it onto the 2×4's that go down the transition and you should be good to go!

   i hope this made sense to you.
   References :

Leave a Reply