Skateboard Planet

6 Responses to “how do i go about buiding a half pike skateboard ramp?”

1. nextel24 Says:
   December 20th, 2008 at 11:20 am

   first you need to get blue prints of a half pipe to see how to make it . make sure the blue prints tell you the size of it you want.
   References :

2. Rich S Says:
   December 20th, 2008 at 11:51 am

   Get a large Pike (from the fishmongers) and cut it in half
   Sellotape part of it to a dustbin and part to the drive and `hey presto` a fishy skateboard ramp for you and your chums to enjoy.
   References :

3. livewire_usa Says:
   December 20th, 2008 at 12:17 pm

   http://www.rickdahlen.com/hpplans/plans.html
   http://www.how2skate.com/index.php?skate=rampplans&rampplan=Quarterpipe

   there is some free plans for a half pipe, if you're new to it though i'd start out with a quarter pipe instead. Youtube also has videos of how to build this stuff.
   References :

4. sk8ersam420 Says:
   December 20th, 2008 at 1:05 pm

   These is where I got my plans from

   http://www.xtremeskater.com/minihalfpipeplans/

   http://www.freeramps.com/
   References :

5. DGK All Day Says:
   December 20th, 2008 at 1:32 pm

   i just built a funbox last weekend, this is the site i used. http://www.xtremeskater.com
   References :

6. alsopanda Says:
   December 20th, 2008 at 2:16 pm

   If I was you I'd start by speaking to the neighbours and make sure they'll be ok with it - ramps can be noisy and they can get it torn down in a flash if you don't get their consent

   Then try and get legit plans - thrasher magazine (online) has some great ones

   You'll need a bit of money though - the wood can be costly

   Good luck

   P.s. it's a half pipe if it's vert (usually about 11 foot high) and a mini-ramp if it's smaller
   References :

Leave a Reply

Name (required)

Mail (will not be published) (required)

Website